January 31

• 0.5 cm for extra black thing (this covers the wires)
• There might be additional wires

January 28

• Stephanie will finish the grating mount by tomorrow night
• Madina will research more about the sensor mount
  • Finish research and brainstorming
  • Next meeting to debrief ideas: January 31st (Tuesday) at 5 pm
    • MB 2nd mech common room

January 18

• Try to use members or trusses instead of a large block of material
  • Stick with similar designs

November 26

• Stephanie almost finished the mount
• Will submit to MyFab (or ask Maggie to print) before the end of this weekend

October 30

• Spoke with Nancy about interest in this project
  • @Stephanie Lu to organize meeting with Nancy and Shivanshi sometime this week to talk about collaboration on the project

October 29

• Spoke with Shivanshi about interest in this project

Objective

To design and print a mount for the FLIR Tau that allows us to attach the sensor to our optical bench.

It is recommended that the mount be modelled after the mechanical interface documented in the FLIR Tau SWIR ISC1202 User’s Guide.