/

• Connected 3.3V and 200 mA. Actual current measured was 44 mA when powered on.

• 5V is not neccessary? Cuz its for coils?

• unsure where adcs data is being stored, trying to figure out how to communicate that with stm

• adcs: 3v3, g, rx/tx

• stm: g, rx, tx

• tx to rx/ rx to tx

• Conclusion:

  • uart_poll_in is not receiving data, garbage values: “�$***”

  

  output: “falsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefalsefae”

  • device is setting up correctly, ≠ NULL

  Potential causes:

• Baud rate:

  • data is not ready when the stm expects it??

• reading from wrong memory?

  • find a memory address located on the board itself

June 25: uart_poll_in = 0, uart input buffer is empty:

• Jenny: data is not transferred back through UART. it must be accessed directly from the memory on the ADCS dev board